Commercial Duct Cleaning in Sioux Falls

The duct is the part of a kitchen exhaust system that matters most and gets cleaned least.

Grease leaves the cook line as vapour, cools as it travels, and condenses on the inside of the ductwork. That deposit is the actual fire load in a commercial kitchen, and it is in the one part of the system nobody can see from the kitchen floor.

What NFPA 96 requires, plainly

A compliant cleaning is the whole system to bare metal: the canopy, the filters, the plenum behind them, every section of ductwork, and the fan. Not the parts that are easy to reach.

That is the standard your fire inspector works from and the one your insurer will ask about after a fire, and it is the reason the NFPA 96 frequency guide exists here. Frequency is set by what you cook and how much: monthly for solid fuel, quarterly for high volume, semiannual for moderate volume.

Where cheap cleanings fall down

The failure is always the same and it is always in the duct.

A canopy and a set of filters can be made to look excellent in an hour. Ductwork takes access panels, scrapers, and someone willing to get inside the system. So the corners that get cut are horizontal runs, the sections between elbows, and the fan housing, and the customer cannot tell because they never see any of it.

Three questions that separate a real service from a wipe-down:

1. May I see photographs from inside the duct and at the fan? Interior shots, not canopy shots.
2. Does the system have access panels, and were they opened? If a run has no access, a proper contractor tells you and offers to install them rather than quietly skipping it.
3. Was the fan lifted? A rooftop fan has to come up off its curb to clean underneath it, which is what hinge kits are for.

Sioux Falls specifics

Sioux Falls has a growing restaurant base and a lot of buildings that have been repurposed at least once. That matters for duct work, because a kitchen exhaust duct installed for a previous tenant’s equipment is frequently the wrong size, the wrong route, or has more horizontal run and more elbows than the current cook line needs. Grease settles anywhere air slows down, so a long horizontal run with a couple of elbows is a grease trap made of sheet metal, and it is the part of the system a cheap cleaner skips.

Building HVAC duct cleaning

Separate from the kitchen exhaust side is building HVAC ductwork: supply and return runs, registers, and coils in commercial buildings. There is no fire-code mandate driving this one, so it is done for indoor air quality, dust and odour reasons, and it is the right call after construction work, after a water event, or when a building has an ongoing complaint nobody can locate.

If you need both, ask whether one company handles both systems and whether doing them on the same visit lowers the price.

What to get in writing

• The whole exhaust system to bare metal, hood through duct to fan.
• Before and after photographs, including inside the duct and at the fan.
• Service documentation and the sticker your inspector looks for.
• After-hours scheduling so the kitchen is not down; confirm the window.
• A note if a run has no access panel, with a quote to add one, rather than a cleaning that quietly skips it.

What it costs

Published on the pricing page, and the cost calculator prices your kitchen without an email.

Book a duct cleaning

Tell us how many hoods you run, what you cook, how the fan is accessed, and when you were last serviced, and we’ll get back to you. If you are not sure the duct has ever been properly cleaned, say so, and ask us to photograph the inside before quoting anything. The service covers Sioux Falls, Brandon, Harrisburg, Tea, and Dell Rapids.